A Mold-DRY element with 50 watts (+/-10%) requires about 1.2 kWh of electricity in 24 hours of full operation. (+/-10%), comparable to a conventional 50 watt light bulb.

When operated with a timer after the first drying phase, the consumption is reduced accordingly.

• Energy remains energy!

The heat produced by Mold-DRY is not lost in the room, and it is exactly this heat that your main heating system has to heat less.

• However, there is still one essential point here – the SAVING of energy!

Damp walls not only provide a breeding ground for mold, but are also bad for the indoor climate and increase heating costs.
Due to increased moisture content in the masonry, the natural insulation capacity changes and the increasingly expensive purchased heat energy escapes uselessly through the damp walls. The moisture causes the masonry to act like a heat conductor, as water conducts energy up to 28 times faster than air.
As a rule of thumb, it can be said that with a moisture content of only 4%, the insulation capacity is already reduced by half. At 10%, the thermal insulation value is even only a quarter, which massively increases heating costs.
With every percent increase in wall dryness through Mold-DRY, you not only prevent mold, but also save heating costs and thus real money.

Mold-DRY is suitable for common wall types such as dry-walls, brick, concrete, or plaster. The only requirement: the surface should be accessible so the infrared can reach it directly.

Absolutely. Mold-DRY is portable, flexible, and requires no structural changes. You can simply remove it after use – ideal for rental properties.

For higher humidity or greater mold infestation, one module is required per running meter of wall (which is why there are also cheaper set offers).
If you place a Mold-Dry heating element horizontally near the floor, it dries damp walls through capillary action over about 1 meter of wall width and the entire wall upwards to about 2.5 – 3 meters room height.

At corners, always install 2 modules (left and right side) so that the drying can penetrate deep into the corner.

For light moisture or slight mold infestation, one module is sufficient per 1.5 running meters.

Yes. Unlike surface treatments, Mold-DRY addresses the moisture inside the wall. This removes mold at its root and prevents it from coming back.